How to enter iPod or iPhone into DFU mode: 8 steps

Table of contents:

How to enter iPod or iPhone into DFU mode: 8 steps
How to enter iPod or iPhone into DFU mode: 8 steps
Anonim

In order to have full control over the device (for example, to jailbreak), you need to put it in DFU mode. Follow this guide to put your device in DFU mode. Before starting, carefully read all the instructions outlined here to take into account all the nuances.

Steps

Method 1 of 2: Putting the device in DFU mode

Put an iPod or iPhone into DFU Mode Step 1
Put an iPod or iPhone into DFU Mode Step 1

Step 1. Connect your device to your computer

To enter DFU mode, the device must be connected to a computer via a USB cable. Make sure iTunes is running.

Put an iPod or iPhone into DFU Mode Step 2
Put an iPod or iPhone into DFU Mode Step 2

Step 2. Turn off the device

Press and hold the Power button until you see the shutdown slider. Swipe the slider to the right to turn off your device. Wait for the device to turn off completely before proceeding.

Put an iPod or iPhone into DFU Mode Step 3
Put an iPod or iPhone into DFU Mode Step 3

Step 3. Press the Power button

Press and hold the Power button for 3 seconds.

Put an iPod or iPhone into DFU Mode Step 4
Put an iPod or iPhone into DFU Mode Step 4

Step 4. Press the Home button

After 3 seconds, press and hold the Home button while holding down the Power button. Do this for another 10 seconds.

Put an iPod or iPhone into DFU Mode Step 5
Put an iPod or iPhone into DFU Mode Step 5

Step 5. Release the Power button

After exactly 10 seconds of holding the two buttons, release the Power button while continuing to hold the Home button. After a few seconds, you will see a message in iTunes that your device has been detected. If the operation was successful, the device screen will remain black.

Method 2 of 2: What is DFU Mode

Put an iPod or iPhone into DFU Mode Step 6
Put an iPod or iPhone into DFU Mode Step 6

Step 1. Enter the device into DFU mode to downgrade the firmware

If you want to install an earlier version of iOS, you need to put the device in DFU mode to install the old system.

DFU mode starts before the device loads the installed operating system. This allows you to access and modify system files

Put an iPod or iPhone into DFU Mode Step 7
Put an iPod or iPhone into DFU Mode Step 7

Step 2. Enter the device into DFU mode for jailbreak

If you are jailbreaking your iPhone, you need to put it into DFU mode in order to load a custom operating system. This action does not apply to all jailbreaks.

Put an iPod or iPhone into DFU Mode Step 8
Put an iPod or iPhone into DFU Mode Step 8

Step 3. Enter the device into DFU mode to cancel jailbreak

If you want to give your iPhone for warranty service, you need to cancel the jailbreak. To do this, you will need to enter the device in DFU mode. Usually, you should do this when you have problems restoring your device through iTunes.

Advice

It is very important to carry out all actions on time when entering the device into DFU mode. You may need a few tries

Popular by topic